Int'l +972 76 540 0180‬ / USA +1 708 736 7842
RFOptic, Inc. Contact us
REQUEST FOR QUOTE FOR CUSTOMIZED SUBSYSTEM

REQUEST FOR QUOTE FOR CUSTOMIZED SUBSYSTEM

Please fill in the form below to get a quote for customized design for a customized subsystem.

    Altimeter, Range or Optical Delay Line Requirements
    Testing & measuring
    Frequency Minimum signal frequency
    Maximum signal frequency
    Type:
    Specify:
    Specify:
    Delay list:
    Delay range & step:
    Zero state: Target zero state value. Optical bypass reaches ~36ns (8ft or 4ft altitude), RF bypass reaches 6ns (4ft or 2ft altitude)
    Bypass options: Target zero state value. Optical bypass reaches ~36ns (8ft or 4ft altitude), RF bypass reaches 6ns (4ft or 2ft altitude)
    RF input power:
    Max Receiver Bandwidth: This BW value is used to insure that the SNR of the ODL is positive at minimum input RF power
    Gain:
    Gain will vary significantly over delay/altitude states when long delay / altitude segments are used
    Flatness is degraded when RF amplifiers are needed.
    Gain control reduces gain variation between delay/altitude states.
    Delay switching speed:
    Fast switching uses a direct LvTTL optical switch control over a rear panel Dsub connector
    Control:
    Ethernet Monitor and Control is provided by a webserver and supports REST API and SNMP protocol
    Enclosure:
    Mini-ODL enclosure supports up to 32μs delays. Delay box solution handles up to 123us, is a lower cost kit of: RFoF TX, a dely enclosure, and an RFoF Rx
    Power:
    The Mini-ODL is powered by an external 5V DC brick power supply
    Other requirements: